The dos and don'ts of mains powered smoke alarms and battery alarms

News
Picture of smoke alarm fixed to the ceiling

Most properties in the UK have battery-operated smoke alarms, but mains powered smoke alarms interlinked between floors are the most reliable method of giving early warning in case of fire and must now be installed in all new homes.

Mains-wired smoke alarms are also required in certain types of alteration and extension work. Mount them in the circulation space at every floor level:

  • In loft conversions
  • When adding new habitable rooms (bedrooms, kitchens, living or dining rooms) above ground floor level
  • When adding a new habitable room at ground floor level that doesn’t have its own exit leading outdoors

Installing new interlinked smoke alarms can be disruptive, so think about the need for detection before you start work. Radio-linked alarms are acceptable; as long as the manufacturer can guarantee the battery back-up will last for 72 hours.

Smoke alarm DOs:

  • Ensure there's at least one alarm on every storey of the dwelling
  • Ensure there's an alarm within 3m of the door to every bedroom.
  • Provide a heat detector to the kitchen if it's open plan to the escape route
  • Mount them 300mm away from walls and light fittings
  • Ensure the electrical installation of the units meets Part P requirements in England and Wales
  • Provide instructions to the end user

Smoke alarm DON'Ts:

  • Install them above staircases where testing and maintenance is dangerous
  • Site them in places where they can become very hot, cold, or subject to a lot of moisture or fumes (bathrooms, kitchens, garages - use a heat detector if need be)

Remember, there are additional requirements for large houses of two or more storeys where one of those storeys exceeds 200m2, so bear this in mind when working on footballers' mansions! If in any doubt, contact your local authority building control team to discuss.

Further information about fire safety

Also view: How to protect residents from carbon monoxide poisoning

 

Please Note: Every care was taken to ensure the information was correct at the time of publication. Any written guidance provided does not replace the user’s professional judgement. It is the responsibility of the dutyholder or person carrying out the work to ensure compliance with relevant building regulations or applicable technical standards.


This article was updated on August 2024

Comments

Reply to: Smoke alarm location

Submitted 5 years 7 months ago

Hi Gary, thanks for your enquiry.

Yes, there is a requirement that detectors should not be mounted adjacent to, or directly above, heaters or air conditioning vents.

Regards,

John, LABC

Smoke / Heat Alarm Placement

Submitted 5 years 7 months ago

I'm wondering if you know the details, or a link to documents behind the 300mm distance from walls and light fittings.
I understand restricted air flow from pendants/hanging lights etc. But, considering most downlights are now LED, do you think heat convection from halogen, EMI from fluorescent lights etc still applies in this day and age.

Smoke Alarm Fittings

Submitted 5 years 6 months ago

Hello there,

I am wondering if there is any regulations on how to install smoke alarms to a ceiling. Can they be fixed with Velcro and still be compliant or do they have to be fixed with screws?

Thank you

Re: Smoke Alarm Fittings

Submitted 5 years 6 months ago

Hi there, thanks for your enquiry.

The smoke detectors need to be installed in accordance with the manufacturers recommendations and their testing/approvals. They are usually fixed by screws.

Regards,

John, LABC

inter connecting smoke alarms

Submitted 5 years 6 months ago

Hi
I have BRK 670 MBX mains interlinked about my bungalow they are a mushroom colour, Can I still mains wire interlink them if I replace one with an Aico Ei141RC which are white in colour. I realise the BRK plug will have to be removed at it junction box and wire to the Aico , question is will the interconnect work or do I need to replace all to one make or another.

Reply to: inter connecting smoke alarms

Submitted 5 years 6 months ago

Hi there, thanks for your enquiry.

For your specific set-up it would be best to seek advice from your local building control team. Find them here: https://www.labc.co.uk/your-local-council-building-control-department — simply enter the postcode of your property and click 'Search'.

Kind regards,

LABC

Interlinked smoke alarms

Submitted 5 years 4 months ago

We are planning a loft extension on a 2 storey building, and trying to decide what smoke alarms to get. We know that the alarms need to be interlinked, but can't find any information about whether they can be linked wirelessly or have to be wired. Are mains powered, wirelessly linked alarms suitable?

Reply to: Interlinked smoke alarms

Submitted 5 years 4 months ago

Hi, thanks for your question.

Assuming your query is regarding a dwelling, the smoke alarms required as a result of the loft extension must be mains powered but can be interconnected wirelessly, provided that this doesn't reduce the lifetime or duration of any standby power below 72 hours.

Kind regards,

LABC

Interlinked System energy usage

Submitted 5 years 3 months ago

We have an Aico Ei166RC mains powered optical smoke alarm (hallway) interlinked wirelessly to four other alarms in our small one floor flat by the local council. Might be an odd question but just wondering is the mains alarm energy efficient/low energy usage? We were not given any detailed instructions other than just to test it every month.

Mains powered

Submitted 5 years 3 months ago

Submitted 1 month 1 week ago

We have had an extension which adds an upstairs bedroom and we have removed an internal wall which means there is no door between the kitchen and the stairs. The house is only 2 floors. We plan to add a heat alarm in the kitchen, a smoke alarm in the livingroom and one in the upstairs hall. These will all be wirelessly linked. Do all alarms need to be mains powered or is it okay if only one is mains and the others are 10y battery? Its suprising they cant all be 10y battery as they need to be replaced every 10y anyway. Thanks.

Ychwanegu sylw newydd

This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.

Sign up to the building bulletin newsletter

Over 48,000 construction professionals have already signed up for the LABC Building Bulletin.



Join them and receive useful tips, practical technical information and industry news by email once every 6 weeks.



Subscribe to the Building Bulletin