When does a replacement kitchen or bathroom need building regulations approval?
The majority of domestic like for like replacement kitchens or bathrooms won't need any form of building regulations approval, but if you're modifying the existing layout then approval may be needed.
This might be due to (from the Building Regulations):
"3(b) the provision or extension of a controlled service or fitting in or in connection with a building;
3(c) the material alteration of a building, or a controlled service or fitting;
3(d) work required by regulation 6 (requirements relating to material change of use);"
A "controlled service or fitting" means;
"A service or fitting in relation to which Part G (Sanitation, hot water safety & water efficiency), H (Drainage & Waste Disposal), J (Combustion appliances & fuel storage systems), L (Conservation of fuel & power) or P (Electrical safety) of Schedule 1 imposes a requirement."
"None of the work, or any part of it, should at any stage result in not complying with or being more unsatisfactory with a relevant requirement where previously it did."
Confused?!
So what does it mean and just how is it relevant to replacement kitchens and bathrooms?
Are you undertaking the provision or extension of a controlled service or fitting? |
Does this require building regulations approval? |
If you move the boiler to another location. | Yes (Part J) |
If you leave the boiler where it is but extend the flue. | Yes (Part J) |
If you install a new gas appliance. |
Yes (Part J) |
If you relocate the sink. |
Yes, if the installation of the fitting or fittings will involve alterations to, or new connections to, a drainage stack or an underground drain, the above ground wastes and drains are controllable (Part H). So is the installation of hot water and wholesome water to the sink (Part G). |
If you relocate the bathroom appliances. |
Yes, if the installation of the fitting or fittings will involve alterations to, or new connections to, a drainage stack or an underground drain, the above ground wastes and drains are controllable (Part H). So is the installation of hot water and wholesome water to the bath, shower, wash basin and bidet. (Part G). |
If you replace a window or external door. | Yes, this is a renovation of a thermal element (Part L1B) |
If you install a new window or external door. | Yes (Part L1B) |
If you install an electrical circuit. |
Yes (Part P) |
If you install or alter fixed electrical equipment in the kitchen. | Yes, if the circuit is within the 'special location' measured 2.25m vertically from the floor or shower head (if higher) and within 600mm of any bath tub or shower tray (Part P). |
If you install or alter fixed electrical equipment in the kitchen. | No, this is non-notifiable work unless a new circuit is provided e.g. installing a new built-in cooker or prefabricated modular lighting is non-notifiable unless a new circuit is required. The work still falls within the scope of (Part P) and should be certificated in accordance with BS7671 and local authorities can still take enforcement action if they consider the work non-compliant and unsafe. |
If you install an extract fan. | Yes, if it requires a new electrical circuit, the extract should go to outside where possible (Part P). |
Are you carrying out a material alteration ?
Removing load bearing walls to accommodate a new layout is a structural alteration. Design and fire resistance will be needed for the new lintel, bearings and foundations may need to be examined for suitability.
Removing doors (or non-load bearing walls) between the kitchen and other rooms, particularly to a staircase, will affect means of escape (B1). Additional precautions in other parts of the property may be needed such as escape windows, interlinked smoke and heat detection, and additional fire resistance (B3). Alternatively you may need to retain the door(s) so it is no worse than before. (Both in Part B.)
Are you carrying out a material change of use?
This classification involves the creation of a dwelling, subdivision to create more than one dwelling or flat or room for residential purposes. The installation of a second kitchen would indicate this likely use and building regulations approval would be required and possibly planning permission.
Could alterations alter the status of a building?
Other than change of use (above), a request may also be received to install a kitchen in a conservatory. Some conservatories are exempt from the requirement for a building regulations application unless the external doors are being removed or the opening widened to open it up to the main house. This removes the exemption status enjoyed by the conservatory and approval is needed.
If that happens, it reverts to an extension of the main house and thermal compliance will be difficult to achieve because of the excessive glazing. An open kitchen/dining space is a popular alteration to properties and care is needed to ensure compliance is possible.
If your building is listed in some way, for its architectural or historic interest and/or is located in a sensitive urban or rural environment (e.g. a conservation area or an area of outstanding natural beauty), then alterations may require additional consent from the planning department.
Remember the reference "Not complying with or being more unsatisfactory with a relevant requirement where previously it did"? This means that the works must not make fabric, services and fittings less compliant than they previously were – or dangerous.
For example, the provision of replacement double glazing must not worsen compliance in relation to: means of escape; air supply for combustion appliances and their flues; and ventilation for health.
Electrical installations must not worsen compliance in relation to:
- structure (depth of chases in walls, notches in floor and roof joists)
- fire safety (provision of detection systems, fire resistance of penetrations through floors and walls)
- site preparation (resistance of service penetrations to rainwater and radon)
- sound (service penetrations on party walls)
- ventilation
- thermal (use of energy efficient lighting)
- access (heights of sockets and switches)
If you're in any doubt then speak to your Local Authority building control team who can offer advice and guidance on how to comply.
Find your local authority's contact details here
Further information
Homeowners, find out much more about how the building regulations apply to your other projects such as:
Please Note: Every care was taken to ensure the information was correct at the time of publication. Any written guidance provided does not replace the user’s professional judgement. It is the responsibility of the dutyholder or person carrying out the work to ensure compliance with relevant building regulations or applicable technical standards.
Sign up to the building bulletin newsletter
Over 48,000 construction professionals have already signed up for the LABC Building Bulletin.
Join them and receive useful tips, practical technical information and industry news by email once every 6 weeks.
Subscribe to the Building Bulletin
Comments
New concealed shower
Submitted 3 years 10 months ago
Many thanks.
Reply
Submitted 3 years 9 months ago
Thank you for getting in touch with LABC.
Because the works relate to the replacement of an existing valve, this would not be classed as “building works” as such, and providing the valve performs equally as well (so there is no material alteration), would not require consent under the provisions of the Building Regulations 2010 (as amended).
Kind regards
Richard, LABC
Home renovation
Submitted 3 years 9 months ago
2. Is replacing entire internal plumbing (hot and cold water pipes) at home a DIY job? Does it have to be notified or certified? Can it be carried out by an experience plumber without certificate being issued?
Reply
Submitted 3 years 7 months ago
1) The extension of an electrical circuit in a living room is not notifiable work for building regulation purposes and can be carried out as a DIY project. You would need to be capable of carrying out the works safely and understand your duty under common law not to be negligent with their installation. If the downlights are cut into the ceiling, this could be a material alteration and require a building regulation application. In this instance, you should contact your local building control team to discuss it further. You can find their contact details by entering your postcode here https://www.labc.co.uk/our-services/find-nearest-local-council-building-control-department.
2) The majority of domestic like for like replacement kitchens or bathrooms won't need any form of building regulations approval, but if you're modifying the existing layout then approval may be needed. Simply replacing hot and cold water pipes can be carried out as a DIY project but you will need to determine for themselves that you are sufficiently competent to do so. An experienced plumber can also carry out the works without notification or the need for a building regulation completion certificate.
Kind regards
Trevor, LABC
Replacement kitchen
Submitted 3 years 6 months ago
regs regarding socket outlets. Mine are about 175mm away from the end of the hob. New regs say they must be 300mm away from the edge of the hob. If so I will have to redesign kitchen.
Maisonette renovation
Submitted 3 years 6 months ago
Add new comment